Challenger V8-5.7L (2010)
6. Open the door and then carefully close the door until the B-pillar top of glass (1) just touches the quarter glass sash seal (2) and check the B-pillar
glass to sash seal gap near the belt line (3). This gap (3) should be adjusted to 6 mm (0.24 in.) to put a cross car pre-load on the door glass. To
adjust the gap open the door and push the top edge of the glass inboard or outboard as needed. Close the door and re-check the gap as needed.
Check that the door glass to quarter glass is flush to +3 mm (0.11 in.) overflush.
7. Tighten the regulator glass clamp fasteners (2) to 10 Nm (89 in. lbs.).
8. From inside the vehicle with the door closed, run the glass full down and then jog it upwards to insure the door glass does not scissor and travel
inboard of the quarter glass sash seal or crush the seal and dislodge it from the retainer. If the door glass travels inboard of the sash seal, you will
need to reduce the door glass pre-load.
9. From outside the vehicle , open and close the door and make sure the A-pillar section of the glass travels properly into the A-pillar seal. If the door
glass crushes or pinches the A-pillar seal, the door glass will need more preload and/or shifted rearward.
10. Install the watershield and trim panel. See: Front Door Panel/Service and Repair/Front Door Watershield - Installation
