Challenger V8-5.7L (2010)
Carpet: Service and Repair
Carpet - Installation
Installation
INSTALLATION
1. Position the rear carpet into the vehicle.
2. Pull the body wire harness take outs and connectors through the appropriate slits in the rear carpet.
3. Fit the rear carpet to the floor panel.
4. Install the push-pin fasteners that secure the rear carpet.
5. Install the sill plates.
6. Install the lower quarter trim panel. See: Trim Panel/Service and Repair/Luggage Compartment Trim/Quarter Trim Panel - Installation.
7. Install the rear seat cushion. See: Seats/Seat Cover/Service and Repair
8. Install the center console. See: Console/Service and Repair/Floor Console - Installation.
9. Install the driver and passenger front seats. See: Seats/Service and Repair/Seat - Installation.
Front
FRONT
NOTE: The front carpet consists of two individual carpets, one for the driver side and one for the passenger side. These carpets can be
removed from and installed into the vehicle individually.
1. Position and fit the front carpet (3) onto the floor panel. Be certain that the rear of the front carpet is fitted over the floor panel front crossmember
and butts up against the front of the rear carpet without interference with the rear floor air duct opening. Be certain that the front of the front carpet
is fitted to the dash panel without interference with the steering column, the accelerator or the heater and air conditioner unit. On the driver side
only, be certain the slit (4) on the inboard edge of the carpet is engaged around the left instrument panel support bracket (5) on the top of the floor
panel transmission tunnel.
2. Install the two push-pin fasteners (1) that secure the outboard edge of the front carpet to the front door opening sill.
3. On the driver side only, install the push-pin fastener (2) that secures the front carpet to the cowl side inner panel above the foot rest.