Challenger V8-5.7L (2010)
Keyless Entry Module: Service and Repair
Passive Entry Module - Removal
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable.
2. Remove the glove box from the instrument panel. See: Interior Moulding / Trim/Glove Compartment/Service and Repair/Instrument Panel Glove
Box - Removal.
3. Reach through the glove box opening (5) and above the glove box latch striker (4) to access and disconnect the two instrument panel wire harness
connectors (2) from the Passive Entry Module (PEM) (3) connector receptacles.
4. Remove the two screws (1) that secure the PEM to the instrument panel base trim substrate.
5. Remove the PEM through the glove box opening.
