Challenger V8-5.7L (2010)
Sunroof / Moonroof Motor: Service and Repair
Sunroof Motor - Installation
INSTALLATION
WARNING: The Excessive Force Limitation (EFL) feature must be calibrated any time a sunroof motor/module is replaced with a new
component. Failure to perform this procedure could result in vehicle damage and/or personal injury. See: Testing and
Inspection/Programming and Relearning CALIBRATION) for the appropriate procedure.
1. Position the power sunroof motor/module (1) in the vehicle.
2. Install the motor/module retaining screws (3). Tighten the screws to 4 Nm (35 in. lbs.).
3. Connect the motor/module electrical connector (2).
4. Connect the battery negative cable and move the sunroof through one open and close cycle to confirm proper system operation.
5. Install the vehicle headliner, See: Interior Moulding / Trim/Headliner/Service and Repair/Headliner - Installation.
6. Perform the sunroof position calibration, See: Testing and Inspection/Programming and Relearning/Sunroof Position Calibration
7. Perform the Excessive Force Limitation (EFL) calibration, See: Testing and Inspection/Programming and Relearning/Excessive Force Limitation
(EFL) Calibration CALIBRATION).
8. Verify proper operation of the power sunroof system.