Challenger V8-5.7L (2010)
Seat Heater: Service and Repair
Heater Pad - Installation
INSTALLATION
1. Peel the adhesive backing from the back of the replacement heating element (2), and place on foam pad directly where the original element was
placed ( there will be adhesive marks on the foam outlining the factory installed element) (1).
CAUTION: During the installation of the replacement heating element, be careful not to fold or crease the element assembly. Folds or creases
will cause premature failure.
2. Connect the new heating element electrical connectors (3 and 4).
3. Connect the battery negative cable.
4. Verify heated seat system operation.
5. Install the appropriate seat cushion See: Seat Cover
NOTE: Make certain the heated seat wire harness is correctly routed through the seat cushion and seat back. The excess wire between the
cushion and back elements should be securely tucked between the rear of the cushion foam and the rear carpet flap of the trim cover.
The factory installed heater element should be completely removed from the system and discarded.