Challenger V8-5.7L (2010)
NOTE: Use this figure in the following step to release the ABM harness connector cover. It shows the location of the release tabs.
5. Disconnect ABM harness connector from antilock brake module (ABM). To do so:
a. Depress tabs on each side of connector cover, then
b. Pull outward and upward on lower half of cover until it locks into position pointing straight outward (2). Connector can then be pulled straight
outward off ABM (1).
6. Pull up on unit (1) and remove from mounting grommets (2) in body side rail.
Integrated Control Unit (ICU) - Installation
