Challenger V8-5.7L (2010)
5. Once front parking brake cable strand is completely seated in cable connector (2), lift cable connector out of retaining fork using pliers and slowly
allow lever mechanism to take up slack in cable.
6. Lay carpet back into place and install retaining clip.
7. Install driver door opening sill scuff plate and cowl side trim.
8. Raise and support vehicle.
9. Install screw (6) and routing clip (4) nuts fastening cable (7) to underside of body (3).
10. Route cable above rear crossmember, then slide cable end (1) (shown with connector) and housing (3) through equalizer (2) above rear axle
differential.
