Challenger V8-5.7L (2010)
NOTE: The horizontal M10 fasteners are 5 mm longer in length, and must be reinstalled in original locations.
NOTE: New M6 fasteners must be used when reinstalling the oil pan. Do not reuse the old M6 fasteners.
5. Align the rear of the oil pan with the rear face of the engine block and install the M10 and M6 oil pan retainers finger tight.
6. Using the sequence shown, tighten the M6 bolts to 5 Nm (44 in. lbs.).
7. Using the sequence shown, tighten the M10 bolts to 54 Nm (39 ft. lbs.).
8. Using the sequence shown, tighten the M6 bolts to 12 Nm (9 ft. lbs.).
9. Lower the vehicle.
10. Using the Engine Lift Fixture 8984A (1), Engine Lift Adapter 8984-UPD (2) and the Engine Support Fixture 8534B (3) lower the engine into
position and remove.
