Challenger V8-5.7L (2010)
Air Door Actuator / Motor: Service and Repair
Blend Door Actuator - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions could result in accidental airbag deployment and possible serious or fatal injury.
1. Disconnect and isolate the negative battery cable.
2. If equipped, remove the instrument panel silencer from the driver side of the instrument panel.
3. Remove the two screws (4) that secure the blend door actuator (1) to the driver side of the HVAC air distribution housing (3).
4. Remove the blend door actuator from the air distribution housing, disconnect the HVAC wire harness connector (2) and remove the actuator.
Blend Door Actuator - Installation
INSTALLATION
1. Position the blend door actuator (1) into the vehicle.
2. Install the blend door actuator onto the driver side of the HVAC air distribution housing (4). If necessary, rotate the actuator slightly to align the
splines on the actuator output shaft (2) with those on the blend door cam (3).
