Challenger V8-5.7L (2010)
1. Disconnect and isolate the negative battery cable.
2. Remove the glove box from the instrument panelSee: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and
Repair/Instrument Panel Glove Box - Removal.
3. Remove the screws (1) that secure the recirculation door actuator (2) to the HVAC air inlet housing (3).
4. Remove the recirculation door actuator from the air inlet housing and disconnect the HVAC wire harness connector (4) and remove the actuator
from the vehicle.
Recirculation Door Actuator - Installation
INSTALLATION
1. Position the recirculation door actuator (1) into the vehicle.
2. Install the recirculation door actuator onto the HVAC air inlet housing (2). If necessary, rotate the actuator slightly to align the splines on the
actuator output shaft (3) with those on the recirculation door pivot shaft (4).
