Challenger V8-5.7L (2010)
6. Tighten pressure hose tube nut at steering gear to 47 Nm (35 ft. lbs.).
7. Install belly pan See: Body and Frame/Exterior Moulding / Trim/Underbody Cover/Service and Repair/Belly Pan - Installation.
8. Lower vehicle.
NOTE: Always use a NEW O-ring on the end of the pressure hose.
9. Lubricate new O-ring on power steering pump end of pressure hose with clean power steering fluid.
10. Install pressure hose (3) to pump (1). Install and tighten bolt (4) to 10 Nm (89 in. lbs.)
11. Install air cleaner housing and inlet tube. See: Filters/Air Cleaner Housing/Service and Repair/Air Cleaner Body - Installation
12. Connect negative battery cable (2) to battery post. It is important that this is performed properly See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery System - Battery Reconnection
