Challenger V8-5.7L (2010)
NOTE: Inspect disc brake pads and parking brake shoes before brake rotor installation. See: Brakes and Traction Control/Disc Brake
System/Brake Pad/Service and Repair/Procedures/Brake Pads - Inspection
4. Install brake rotor (3) over wheel mounting studs and onto hub (1).
5. Install disc brake caliper and adapter assembly (3) over brake rotor.
6. Install mounting bolts (1) securing caliper adapter (3) to knuckle (2). Tighten bolts to 115 Nm (85 ft. lbs.).
NOTE: Always install a new hub nut. The original hub nut is one-time use only and should be discarded when removed.
7. Install hub nut (1) on end of half shaft (2). While a helper applies brakes to keep hub from turning, tighten hub nut to 213 Nm (157 ft. lbs.).
