Challenger V8-5.7L (2010)
-
Transmission Assembly Replacement
-
Transmission Control Module Replacement
-
Clutch Plate and/or Seal Replacement
-
Electrohydraulic Unit Replacement or Recondition
1. With the scan tool, reset the Transmission adaptives. Resetting the adaptives will set the adaptives to factory settings.
NOTE: Perform the Coast Down Adaptations first. The Transmission Temperature must be greater than 60°C (140°F) and less than 70°C
(158°F). Failure to stay within these temperature ranges will void the procedure.
2. Drive the vehicle until the transmission temperature is in the specified range.
3. Perform 4 to 5 coast downs from 5th to 4th gear and then 4th to 3rd gear.
NOTE: For Upshift adaptation, the Transmission temperature must be greater than 60°C (140°F) and less than 100°C (212°F). Failure to stay
within these temperature ranges will void this procedure.
4. From a stop, moderately accelerate the vehicle and obtain all forward gear ranges while keeping the Engine RPM below 1800 RPM. Repeat this
procedure 4 to 5 times.
5. Obtaining 5th gear may be difficult at 1800 RPM. Allow the transmission to shift into 5th gear at a higher RPM then lower the RPM to 1800 and
perform manual shifts between 4th and 5th gears using the shift lever.
6. The TCM will store the adaptives every 10 minutes. After completion of the adaptation procedure make sure the vehicle stays running for at least
10 minutes.
7. It is possible to manually store the adaptives under the 10 minute time frame using the scan tool Store Adaptives procedure.
Flash Programming
FLASH PROGRAMMING
NOTE: The wiTECH diagnostic application is the preferred method for flashing ECUs.
NOTE: Help using the wiTECH diagnostic application for flashing an ECU is available by selecting "Help" then "Help Contents" at the top
of the wiTECH diagnostic application window.
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
NOTE: The StarMobile Desktop Client may also be used to perform this flash procedure.
Powertrain Control Module - Programming
PCM/ECM REPROGRAMMING - GAS
See: Computers and Control Systems/Testing and Inspection/Programming and Relearning/PCM/TCM Reprogramming Perform the PCM/TCM
PROGRAMMING procedure.
Module/Programming Order Replacement Guide
MODULE/PROGRAMMING ORDER REPLACEMENT GUIDE
Match the module row with the condition that applies, after module replacement follow the chart down and program the modules in the chart order.
WIN WITHOUT PEM MODULE
