Challenger V8-5.7L (2010)
airbag. Torque the two screws (5) to 10 Nm (89 in. lbs.).
WARNING: Do not connect the battery negative cable See: Testing and Inspection/Component Tests and General Diagnostics . If the system test is
not performed first it may result in serious or fatal injury.
Passenger Air Bag - Removal
REMOVAL
DEPLOYED PASSENGER AIRBAG
For deployed passenger airbags, the instrument panel top pad must be replaced.
1. Open hood.
2. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service.
Failure to do so may result in accidental airbag deployment, and serious or fatal injury.
3. Remove instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -
Removal.
4. Disconnect the passenger airbag electrical connector (3).
5. Remove the four left and right passenger airbag mounting screws (1).
6. Remove the two lower passenger airbag mounting bolts (2).
7. Separate passenger airbag from instrument panel.
8. Remove and inspect all reusable components from the instrument panel and transfer to the new instrument panel top pad.
9. Clean powder residue from interior of vehicle See: Service and Repair.
NONDEPLOYED PASSENGER AIRBAG
