Challenger V8-5.7L (2010)
Impact Sensor: Service and Repair
Impact Sensor - Removal
REMOVAL
FRONT IMPACT SENSOR
1. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service.
Failure to do so may result in accidental airbag deployment, which may result in serious or fatal injury.
NOTE: If replacing the left front impact sensor, the air intake system needs to be removed.
2. Disconnect the front impact sensor electrical connector (3).
3. Remove the two front impact sensor retaining screws (2).
4. Remove the impact sensor.
SIDE IMPACT SENSOR
DOOR MOUNTED SIDE IMPACT SENSOR
1. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service.
Failure to do so may result in accidental airbag deployment, which may result in serious or fatal injury.
2. Remove the door trim panel.See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair/Front Door
Trim Panel - Removal.
3. Disconnect the side impact sensor electrical connector (4).
