Challenger V8-5.7L (2010)
7. Remove the right front wheelhouse splash shield to gain access to the battery positive cable bulkhead outside terminal, See: Body and
Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Splash Shield - Removal. Connect the voltmeter to measure between the
battery positive cable bulkhead outside terminal and the starter solenoid B(+) terminal stud. Rotate and hold the ignition switch in the Start
position. Observe the voltmeter. If the reading is above 0.2 volt, clean and tighten the battery positive cable bulkhead outside terminal connection.
Repeat the test. If the reading is still above 0.2 volt, replace the battery front positive cable, See: Service and Repair/Battery Cables - Removal.
8. Remove the right front carpet to gain access to the battery positive cable bulkhead inside terminal. Connect the voltmeter to measure between the
battery positive cable terminal clamp and the battery positive cable bulkhead inside terminal connection. Rotate and hold the ignition switch in the
Start position. Observe the voltmeter. If the reading is above 0.2 volt, clean and tighten the battery positive cable bulkhead inside terminal
connection. Repeat the test. If the reading is still above 0.2 volt, replace the battery rear positive cable, See: Service and Repair/Battery Cables -
Removal.
