Challenger V8-5.7L (2010)
4. Connect battery cable to TIPM. Tighten the nut to 20 - 28 Nm (15 - 21 ft. lbs.).
5. Close the battery cable nut cover.
6. Connect negative battery cable (2).
7. Insert the ignition key and turn it to the RUN position and wait twenty seconds. The TIPM will collect the necessary vehicle configuration and
VIN data from the CCN and PCM at this time. After twenty seconds turn the ignition key to the OFF position and then back to the ON position
and verify proper vehicle systems operation.
