Challenger V8-5.7L (2010)
Yes
-
Go To 8
No
-
Repair the short to ground in the (T26) Clutch Upstop Switch Signal circuit.
-
Perform the PCM VERIFICATION TEST. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests/PCM Verification Test.
8. (T26) CLUTCH UPSTOP SWITCH SIGNAL CIRCUIT OPEN OR HIGH RESISTANCE
1. Connect the PCM Pinout Box 8815.
2. Measure the resistance of the (T26) Clutch Upstop Switch Signal circuit from the Clutch Interlock Switch harness connector to the appropriate
terminal of the PCM Pinout Box 8815.
Is the resistance below 5.0 Ohms?
Yes
-
Go To 12
No
-
Repair the open or high resistance in the (T26) Clutch Upstop Switch Signal circuit.
-
Perform the PCM VERIFICATION TEST. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests/PCM Verification Test.
9. (T141) CLUTCH INTERLOCK SIGNAL CIRCUIT SHORTED TO VOLTAGE
