Challenger V8-5.7L (2010)
4. Install halves of Support Clamp (1), Ball Joint Remover/Installer 9320-1 (2) over ball joint (2) and around knuckle surface (3) as shown. Install
and snug Support Clamp (1) screws from underside.
5. Position knuckle (1) over tools guiding top of ball joint inside of Receiver (6), then hand tighten Press screw-drive (4) until Remover (3) comes
into contact with bottom of ball joint (2).
NOTE: When positioning knuckle over tools, make sure Receiver, Ball Joint Remover/Installer 9320-5, sets into recessed area (4) of Support
Clamp, Ball Joint Remover/Installer 9320-1.
