Challenger V8-5.7L (2010)
7. Tighten pressure hose tube nut at steering gear to 47 Nm (35 ft. lbs.).
8. Install belly pan See: Body and Frame/Exterior Moulding / Trim/Underbody Cover/Service and Repair/Belly Pan - Installation.
9. Lower vehicle.
NOTE: Always use a NEW O-ring on the end of the pressure hose.
10. Lubricate new O-ring on power steering pump end of pressure hose with clean power steering fluid.
11. Install pressure hose (2) to pump (1). Tighten pressure hose tube nut to 47 Nm (35 ft. lbs.).
12. Install air cleaner housing and inlet tube. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner
Housing/Service and Repair/Air Cleaner Body - Installation
