Challenger V8-5.7L (2010)
28. Clean and install the plastic underbody shield (Figure 15).
29. Lower the vehicle from the hoist.
30. Install air cleaner housing and inlet tube.
31. Continue with Section I. Fill and Bleed the Power Steering Hydraulic System.
CAUTION:
If the air is not purged from the power steering system correctly, power steering pump failure could result.
G. Replace Power Steering Pressure Hose (LX All Wheel Drive Models)
NOTE:
The following procedure is required if the power steering pressure hose required replacement per the inspection in Section "A."
1. Open the hood and remove the power steering reservoir.
2. Using a suction gun, siphon the power steering fluid from the power steering pump reservoir.
3. On Hemi engine only, remove the engine cover (Figure 17).
4. Remove the air cleaner housing and inlet tube to the throttle body (Figure 17).
5. Using Mopar Brake Parts Cleaner (or equivalent) and compressed air, clean the area around the power steering pump where the tube nut and low
pressure supply elbow screws into the power steering pump
CAUTION:
Failure to clean the area around the power steering pump tube nut and low pressure supply elbow at the power steering pump could allow dirt to enter
the power steering hydraulic system during power steering pressure hose replacement.
