Recall - Power Steering Pressure Hose Replacement (Challenger V8-57L 2010)
9. Remove the screw securing the power steering pressure hose routing clamp to the front of the engine cradle (Figure 16).
10. Remove the screw fastening routing clamps securing the power steering pressure and return hoses to the right side of the engine cradle.
11. Using Mopar Brake Parts Cleaner (or equivalent) and compressed air, clean the area where the power steering pressure and return hose tube nuts
screw into the steering gear.
CAUTION:
Failure to clean the area around the power steering hose tube nuts at the steering gear before disassembly could allow dirt to enter the power steering
hydraulic system during power steering pressure hose replacement.
12. Unthread the power steering pressure hose tube nut from the steering gear.
13. Lower the vehicle from the hoist.
14. Remove and discard the power steering pressure hose from the vehicle.
15. Lubricate the rubber O-rings on each end of the new power steering pressure hose with clean power steering fluid.
16. Install the new power steering pressure hose in the engine compartment.
17. Raise the vehicle on the hoist.
18. Install the power steering pressure hose to the steering gear port. Do not tighten the tube nut at this time.
19. Route the power steering pressure hose the along right side of the engine cradle. Position the power steering pressure hose routing clamp over return
hose routing clamp, then install the screw securing hoses to right side of the engine cradle.
20. Tighten the power steering pressure hose tube nut at steering gear to 35 ft. lbs. (47 N.m).
21. Lower the vehicle from the hoist.
22. Install the power steering pressure hose to the power steering pump. Tighten the power steering pressure hose tube nut to 35 ft. lbs. (47 N.m).
23. Route the power steering pressure hose along front of the engine cradle. Install the retaining screw through the routing clamp, securing the hose to
the front of the engine cradle (Figure 16).
24. Install the low pressure supply line elbow onto the power steering pump.
25. Using Mopar Brake Cleaner or equivalent, clean off any spilled power steering fluid from the power steering pump.
26. Raise the vehicle on the hoist.
27. Using Mopar Brake Cleaner or equivalent, clean any spilled power steering fluid from the engine cradle and crossover.
