Challenger V8-5.7L (2010)
16. Install the new power steering pressure hose to the steering gear port. Do not tighten the tube nut at this time.
17. Route the power steering pressure hose along right side of the engine cradle. Position the power steering pressure hose routing clamp over return
hose routing clamp, then install the screw securing hoses to right side of the engine cradle.
18. Tighten the power steering pressure hose tube nut at steering gear to 35 ft. lbs. (47 N.m).
19. Lower the vehicle from the hoist.
20. Install the power steering pressure hose to the power steering pump. Tighten power steering pressure hose tube nut to 35 ft. lbs. (47 N.m).
21. Using Mopar Brake Cleaner or equivalent, clean off any spilled power steering fluid from the power steering pump.
22. Raise the vehicle on the hoist.
23. Using Mopar Brake Cleaner or equivalent, clean any spilled power steering fluid from the engine cradle and crossover.
24. Clean and install the plastic underbody shield.
25. Lower the vehicle from the hoist.
26. Install air cleaner housing and inlet tube (Figure 17).
27. On Hemi engine only, install the engine cover.
28. Continue with Section I. Fill and Bleed the Power Steering Hydraulic System.
CAUTION:
If the air is not purged from the power steering system correctly, power steering pump failure could result.
H. Replace Power Steering Pressure Hose (LC/LX Models W/5.7L/6.1L Engine/Rear Wheel Drive)
NOTE:
The following procedure is required if the power steering pressure hose required replacement per the inspection in Section "A."
1. Open the hood and remove the power steering reservoir cap.
2. Using a suction gun, siphon the power steering fluid from the power steering pump reservoir.
3. Remove the engine cover, air cleaner housing and inlet air tube (Figure 20).
4. Using Mopar Brake Parts Cleaner (or equivalent) and compressed air, clean the area around the power steering pump where the tube nut and low
pressure supply elbow screws into the power steering pump
CAUTION:
