Challenger V8-5.7L (2010)
Power Steering Pump: Service and Repair
Power Steering Pump Pulley - Removal
Automatic Transmission
AUTOMATIC TRANSMISSION
1. Remove power steering pump from engine. See: Power Steering Pump - Removal.
CAUTION: Do not hammer on power steering pump pulley or shaft to remove power steering pump pulley. Damage to pulley and power
steering pump will occur.
CAUTION: It is very important to use Puller 9962, to remove pulley from power steering pump shaft. Use of other pullers can damage or
break pulley and pump shaft.
2. Coat Screw-Drive (1) with lubricant and thread into Puller Body (2).
NOTE: Two Buttons come with Puller kit (9962-3 and 9962-4). Be sure to use Button that best fits end of pump shaft to avoid damage to
Button or pump shaft.
3. Insert Button (4) 9962-4, into end of Screw-Drive. Be sure not to misplace ball bearing that resides behind Button.
4. Assemble Puller 9962, over end of pump shaft and pulley hub.
a. Place Button on end of Screw-Drive against pump shaft.
b. Assemble Collets (3) 9962-2, surrounding Puller Body (1) and pulley hub flange, then slide the Collet Sleeve over the Collets.
c. Hand tighten Screw-Drive (2) taking up any slack in Puller.
5. Hold Puller Body stationary while turning Screw-Drive until pulley is removed from power steering pump shaft.