Challenger V8-5.7L (2010)
5. If vehicle is equipped with AWD, make sure spacers (1) on top of crossmember mount bushings (2) on side of repair are in position.
6. Carefully raise jack, guiding coil spring and upper end of shock absorber (4) into mounted positions.
7. Install shock absorber upper mounting screws (2). Tighten upper mounting screws to 52 Nm (38 ft. lbs.).
NOTE: Rear crossmember mounting bolts (2) are longer than front mounting bolts (3). Do not interchange mounting bolts.
8. Install crossmember mounting bolts (2 and 3). Snug, but do not fully tighten bolts at this time.
