Challenger V8-5.7L (2010)
9. Loosen nut (4) attaching upper ball joint stud (1) to knuckle. Back nut off until nut is even with end of stud. Keeping nut on at this location will
help keep end of stud from distorting while using Puller in next step.
CAUTION: In following step, use care not to damage ball joint seal boot while sliding Ball Joint Remover 9360, into place past seal boot.
10. Using Ball Joint Remover 9360 (2), separate upper ball joint stud (1) from knuckle.
11. Remove nut (4) from end of upper ball joint stud (1).
