Challenger V8-5.7L (2010)
Front Steering Knuckle: Service and Repair
Assembly
BALL JOINT
NOTE: To perform this procedure, it works best to mount Ball Joint Press C-4212F in a vise.
1. Place Ball Joint Remover/Installer 9320-4 (1) into cup area of Ball Joint Press C-4212F (3) as shown and tighten set screw.
2. Place Ball Joint Remover/Installer 9320-3, onto end of screw-drive of Ball Joint Press C-4212F (3) as shown. Note: This is the reverse of how
Remover is installed on screw-drive for removal.
3. Start NEW ball joint (1) into bore of knuckle (2).
