Challenger V8-5.7L (2010)
8. Install three nuts (2) fastening shock assembly (4) to shock tower (3). Tighten nuts to 27 Nm (20 ft. lbs.).
9. If equipped, align shock tower cap (1) with shock mounting nuts (2) and snap into place.
Removal
REMOVAL
1. Raise and support vehicle, See: Wheels and Tires/Vehicle Lifting/Service and Repair.
.
2. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
3. Position under-hoist utility jack or jack stand under outer spring link adding just enough support to keep suspension from going into full-rebound
when shock absorber mounting bolts are removed.
