dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

All Technical Service Bulletins for Wheel Fastener: > < Recall 09V420000: Front Spindle Nut Missing|Page 4600
Page 1
background image

Wheel Fastener: Customer Interest
Wheels/Tires - Highway Speed Vibration

NUMBER: 22-003-10

GROUP: Tires and wheels

DATE: August 13, 2010

THIS SERVICE BULLETIN IS ALSO BEING RELEASED AS RAPID RESPONSE TRANSMITTAL 10-050. ALL APPLICABLE VIN's HAVE
BEEN LOADED.

SUBJECT:
Slight Vibration at Highway Speeds

OVERVIEW:
This bulletin involves the removal of all four wheels and the Tinnerman push nuts.

MODELS:

2010

(LC)

Challenger

2010

(LX)

300/Charger

NOTE

This bulletin applies to sales code (WP6 and WPI) built after April 17, 2009 (MDH0417XX) and before May 27, 2010 (MDH0527XX) and sales
code (WPT) built after September 24, 2009 (MDH0724XX) and before July 07, 2010 (MDHO707XX).

SYMPTOM/CONDITION:
The customer may experience vehicle vibrations which are commonly felt in the steering wheel. A number of vehicles may have been shipped with 
wheels that do not have the relief cut to accommodate the Tinnerman push nuts used during vehicle assembly. Dealers are required to remove all 4
wheels to remove and discard the Tinnerman push nuts that are used during initial vehicle assembly at the plant.

DIAGNOSIS:
If the vehicle operator experiences the symptom/condition, perform the repair procedure.

REPAIR PROCEDURE:

1. Raise the vehicle and remove all 4 wheels.

2. Using side cutters remove and discard the Tinnerman nuts/washers.

3. Following the procedure outlined on DealerConnect, reinstall the wheels and torque lug nuts to 150 Nm (110 ft lbs).

TIME ALLOWANCE:

FAILURE CODE:

Disclaimer:

This bulletin is supplied as technical information only and is not an authorization for repair.

All Technical Service Bulletins for Wheel Fastener: > < Recall 09V420000: Front Spindle Nut Missing|Page 4600