Challenger V8-5.7L (2010)
Clutch Release Bearing: Service and Repair
Installation
INSTALLATION
1. Position the clutch release bearing/slave cylinder (3) onto input shaft.
2. Install the two bolts (2) that secure the clutch release bearing/slave cylinder to the transmission (1). Tighten the bolts to 20 Nm (15 ft. lbs.).
3. Install the transmission See: Manual Transmission/Transaxle/Service and Repair/Removal and Replacement/TR6060 Manual Transmission -
Installation.
4. Lower the vehicle.
NOTE: While bleeding the clutch system be certain the clutch pedal returns to the most upright position. It may take as many as two hundred
clutch strokes to bleed the system.
5. Bleed the clutch system See: Service and Repair.