Challenger V8-5.7L (2010)
Drive/Propeller Shaft: Service and Repair
Propeller Shaft - Removal
Automatic Transmission
AUTOMATIC TRANSMISSION - NON-SRT
CAUTION: Propeller shaft removal is a two-man operation. Never allow propeller shaft to hang from the center bearing, or while only
connected to the transmission or rear axle flanges. A helper is required. If a propeller shaft section is hung unsupported, damage
may occur to the shaft, coupler, and/or center bearing from over-angulation. This may result in driveline vibrations and/or
component failure.
1. With vehicle in neutral, position on hoist.
2. Apply alignment index marks (3) on the transmission and axle flanges (2) and rubber couplers (1).
3. Remove rear exhaust system. See: Engine, Cooling and Exhaust/Exhaust System/Muffler/Service and Repair/Removal.
4. Remove heat shield retainers (2) and remove the heat shield (1).
