Challenger V8-5.7L (2010)
9. Install heat shield (1).
10. Install rear exhaust system.See: Engine, Cooling and Exhaust/Exhaust System/Muffler/Service and Repair/Installation
Manual Transmission
MANUAL TRANSMISSION
CAUTION: Propeller shaft installation is a two-man operation. Never allow propeller shaft to hang from the center bearing, or while only
connected to the transmission or rear axle flanges. A helper is required. If a propeller shaft section is hung unsupported, damage
may occur to the shaft, coupler, and/or center bearing from over-angulation. This may result in driveline vibrations and/or
component failure.
COUPLER/DAMPER SERVICE
1. Install three bolts with washers and nuts and torque to 91 Nm (67 ft. lbs.) torque.