Challenger V8-5.7L (2010)
NOTE: To prevent damage or imbalance, washers must be placed on fasteners that attach rubber coupler to the pinion yoke.
NOTE: To prevent damage or imbalance, washers must be installed between fastener heads and the rubber coupler.
6. Raise rear axle assembly into position. Align propeller shaft index marks (3) and start propeller shaft coupler-to-axle bolt/nuts by hand.
NOTE: If re-using the original rear axle-to-crossmember bolts, clean the rear axle-to-crossmember bolts and apply a patch of blue
MOPAR(R) Lock & Seal medium strength thread locker to the rear axle-to-crossmember bolts. New bolts have a thread lock patch,
and do not require application of blue MOPAR(R) Lock & Seal medium strength thread locker
7. Install right rear axle-to-crossmember bolt (1) and tighten to 220 Nm (162 ft. lbs.).
