Challenger V8-5.7L (2010)
10. Install the front mount bolt cover (1).
11. Again verify halfshaft inner joints are fully engaged to axle assembly.
12. Remove transmission jack (1).
13. If used, remove screw-type under-hoist jack stands (2).
NOTE: If re-using original fasteners, apply a patch of blue MOPAR(R) Lock & Seal medium strength thread locker to the propeller shaft
coupler-to-axle flange fasteners. New fasteners have a thread lock patch, and do not require application of blue MOPAR(R) Lock &
Seal medium strength thread locker.
14. Install the propeller shaft coupler-to-axle flange fasteners. Tighten the propeller shaft coupler-to-axle flange fasteners (2) to 122 Nm (89 ft. lbs.).
