Challenger V8-5.7L (2010)
Seals and Gaskets: Service and Repair
Extension Housing Seal - Installation
INSTALLATION
1. Install output shaft seal into extension housing (1) with Installer 7884 (2).
2. Install propeller shaft.
CAUTION: The drive shaft strap bolts use a Loctite patch, the bolts must be replaced or cleaned and applied Mopar (R) Lock AND Seal
Adhesive or equivalent. Replace drive shaft joint straps whenever they are removed. The straps slightly deform when torqued in
place. Reuse of the straps may result in reduced clamp load on the universal joint cap.
3. Check transmission fluid level.
4. Install belly pan.
