Challenger SRT-8 V8-6.1L (2009)
8. Remove caliper mounting bolts (1).
9. Remove brake caliper (2) with pads from knuckle (3) and brake rotor (3).
10. If brake pads need to be removed from caliper.
NOTE: These calipers are not serviceable. Do not attempt disassembly.
Rear
REMOVAL
NOTE: Before proceeding, See: Service Precautions/Technician Safety Information See: Service Precautions/Vehicle Damage Warnings .
1. Disconnect and isolate battery negative cable (2) from battery post.
2. Using a brake pedal holding tool, depress brake pedal past its first inch of travel and hold it in this position. Holding pedal in this position will
isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open.
3. Raise and support vehicle. See: Maintenance/Vehicle Lifting/Service and Repair
