Challenger SRT-8 V8-6.1L (2009)
2. If equipped, remove the film from the brake pad double sticky isolator.
3. Slide NEW inboard (2) and outboard brake pads into opening (1) in disc brake caliper. If installing rear brake pads, make sure beveled end of
each pad lining is directed against the direction the rotor is rotating in when vehicle is moving forward, in other words, the rear pads
need to have beveled end facing upward.
4. From inboard side, slide upper brake pad support pin (2) through caliper (3) and upper holes in both brake pads (1). Ensure that small end of
support pin is in hole (4) in outboard half of caliper.
5. Install upper end of brake pad spring clip (2) under upper brake pad support pin (1).
