Challenger SRT-8 V8-6.1L (2009)
NOTE: Before measuring hub runout, clean the hub face surface with an appropriate cleaner. This provides a clean surface to get an accurate
indicator reading.
9. Mount Dial Indicator C-3339A (2), to the knuckle. Position Dial Indicator stem so it contacts hub face (1) near outer diameter. Care must be taken
to position stem outside of stud circle, but inside of chamfer on the hub rim.
10. Slowly rotate hub measuring runout. Hub runout should not exceed 0.01 mm (0.0004 inch). If runout exceeds this specification, the hub must be
replaced. See: Maintenance/Wheels and Tires/Wheel Bearing/Service and Repair/Front Hub and Bearing - Removal.
11. If hub runout does not exceed this specification, install original rotor back on hub, aligning chalk mark on rotor (2) with a wheel mounting stud,
two studs apart from original stud (1).
