Challenger SRT-8 V8-6.1L (2009)
7. Remove two brake fluid reservoir seal grommets (2) from master cylinder housing (1).
Brake Master Cylinder Reservoir - Installation
INSTALLATION
1. Install NEW brake fluid reservoir sealing grommets (2) in master cylinder housing (1).
2. Lubricate reservoir mounting area with fresh clean brake fluid. Place reservoir in position over sealing grommets. Seat reservoir into sealing
grommets using a rocking motion while firmly pressing down on fluid reservoir. Once installed, make sure fluid reservoir is touching the top of
both sealing grommets (2) or reservoir is not properly installed.
3. Install fluid reservoir mounting screw (3). Tighten screw to 28 Nm (250 in. lbs.) torque.
