Challenger SRT-8 V8-6.1L (2009)
3. Install the crossmember bolts (1,3) and tighten to 68 Nm (50 ft. lbs.).
4. Lower the transmission and remove jack.
5. Instal the rear mount isolator bolts (2) and tighten to 47 Nm (35 ft. lbs.).
Front
INSTALLATION
1. Install the engine mount brackets, if removed.
2. Position hydramount (3) on the engine. Install fasteners (1,2) and tighten to 95 Nm ( 70 ft. lbs.).
3. Install engine mount nuts (1,2) and tighten to 95 Nm ( 70 ft. lbs.).
