Challenger SRT-8 V8-6.1L (2009)
3. Remove clean air hose from throttle body.
4. Remove retaining bolt (2) and remove air cleaner housing (1).
5. Drain the cooling system.
6. Remove the accessory drive belt. See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Removal and
Replacement/Serpentine Accessory Drive Belt - Removal.
7. Remove the cooling fan.
8. Remove the fan shroud.
NOTE: It is not necessary to disconnect A/C lines or discharge freon.
9. Remove A/C compressor and set asideSee: Heating and Air Conditioning/Compressor HVAC/Service and Repair/A/C Compressor - Removal.
10. Remove the generator.
11. Remove the upper radiator hose.
12. Disconnect both heater hoses at the timing cover.
13. Disconnect the lower radiator hose at engine.
14. Remove accessory drive belt tensioner and both idler pulleys.
15. Remove the crankshaft damper See: Cylinder Block Assembly/Harmonic Balancer - Crankshaft Pulley/Service and Repair/Vibration Damper -
Removal.
NOTE: Do not remove the hoses from the power steering pump.
16. Remove power steering pump and set aside.
