Challenger SRT-8 V8-6.1L (2009)
1. Position the front floor distribution duct (2) to the bottom of the HVAC air distribution housing (3).
2. Install the six screws (1) that secure the front floor distribution duct to the air distribution housing. Tighten the screws to 2 Nm (17 in. lbs.).
3. Install the air distribution housing, See: Floor Distribution Duct - Installation.
INTERMEDIATE FLOOR DISTRIBUTION DUCTS
1. Install the driver side rear intermediate floor distribution duct (5) and the passenger side rear intermediate floor distribution duct (3) into the slots
in the floor support (4).
2. Connect the driver side front intermediate floor distribution duct (6) to the driver side rear intermediate floor distribution duct.
3. Connect the driver side front intermediate floor distribution duct to the front floor distribution duct (1).
4. Engage the driver side rear intermediate floor distribution duct to the stud located on the driver side of the floor support.
5. Connect the passenger side front intermediate floor distribution duct (2) to the passenger side rear intermediate floor distribution duct.
6. Connect the passenger side front intermediate floor distribution duct to the front floor distribution duct.
7. Engage the passenger side front intermediate floor distribution duct to the stud located on the passenger side of the floor support.
8. Install the carpet onto the front floor panel and under the instrument panel, .
9. Install the front seats, See: Body and Frame/Seats/Service and Repair/Seat - Installation.
10. Install the center floor console,See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console - Installation.
Instrument Panel Duct - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions could result in accidental airbag deployment and possible serious or fatal injury.
NOTE: Take the proper precautions to protect the front face of the instrument panel from cosmetic damage.
