Challenger SRT-8 V8-6.1L (2009)
1. Disconnect and isolate the negative battery cable.
2. Remove the cowl top panel from the dash panel, See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and Repair/Cowl Panel Cover -
Removal.
3. Remove the two bolts (1) that secure the strut support (2) to the driver side strut tower (3).
4. Disengage the wiper motor (5) from the bracket (4) located on the strut support.
5. Disengage the retainer that secures the wire harness (4) to the bottom of the strut support (3).
6. Remove the purge solenoid (5) from its mounting bracket and position the solenoid out of the way.
7. Remove the two bolts (1) that secure the strut support to the passenger side strut tower (6) and remove the support from the engine compartment.
8. Position the powertrain control module (PCM) out of the way.
