Challenger SRT-8 V8-6.1L (2009)
3. Position the insulator (4) into its installed location and install the push-pin retainer (5) that secures the insulator to the front of the fresh air inlet
housing (2).
4. Install the push-pin retainer (1) that secures the fresh air inlet housing to the right inner fender (6).
5. Reach under the fresh air inlet housing and install the wire harness retainer (3) into the bottom of the air inlet housing, if equipped.
6. Position the powertrain control module (PCM) into its installed location.
7. Position the strut support (3) into the engine compartment and loosely install the two bolts (1) that secure the strut support and the PCM to the
passenger side strut tower (6).
8. Install the purge solenoid (5) onto its mounting bracket located on the right strut tower.
9. Engage the retainer that secures the wire harness (4) to the bottom of the strut support.
