Challenger SRT-8 V8-6.1L (2009)
9. Remove the evaporator temperature sensor, See: Evaporator Temperature Sensor / Switch/Service and Repair/Evaporator Temperature Sensor -
Removal.
10. Remove the two bolts (1) that secure the A/C expansion valve (2) to the evaporator tube tapping block located within the foam seal (3).
11. Remove the A/C expansion valve from the evaporator tube tapping block and foam seal.
12. Remove the O-ring seals from the evaporator tube fittings and discard.
13. Install plugs in, or tape over the opened evaporator tube fittings and all expansion valve ports.
14. Remove the HVAC wiring harness (1).
15. Remove the ten screws (2) that secure the upper half of the HVAC housing (3) to the lower half of the HVAC housing (4).
16. Separate the two halves of the HVAC housing.
