Challenger SRT-8 V8-6.1L (2009)
Hose/Line HVAC: Service and Repair
A/C Discharge Line - Removal
REMOVAL
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Heating and Air
Conditioning/Service Precautions/Warning and See: Heating and Air Conditioning/Service Precautions/Caution . Failure to follow these
instructions may result in serious or fatal injury.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Recovery.
3. Remove the air cleaner housing See: Filters/Air Cleaner Housing/Service and Repair/Air Cleaner Body - Removal.
4. Reach through the headlamp opening in the upper radiator support and remove the nut (1) that secures the A/C discharge line (2) to the A/C
condenser (5).
5. Disconnect the A/C discharge line from the A/C condenser and remove and discard the dual plane seal.
6. Install plugs in, or tape over the discharge line fitting and condenser inlet port.
NOTE: Typical A/C compressor and refrigerant lines shown.
7. Remove the nut (2) that secures the A/C discharge line (4) to the A/C compressor (5).
8. Disconnect the A/C discharge line from the A/C compressor and remove and discard the dual plane seal.
9. Install plugs in, or tape over the opened refrigerant line fitting and the compressor port.
10. Remove the A/C discharge line from the engine compartment.
A/C Discharge Line - Installation
INSTALLATION
