Challenger SRT-8 V8-6.1L (2009)
9. Connect the oxygen sensor (2) connectors.
10. Lower the vehicle.
11. Connect the negative battery cable.
12. Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.
Left Hand Catalytic Converter
LEFT HAND CATALYTIC CONVERTER
1. Install the catalytic converter (3) onto the exhaust manifold ball flange. Finger tighten the nuts.
2. Install the muffler and resonator assembly See: Engine, Cooling and Exhaust/Exhaust System/Muffler/Service and Repair/Installation.
3. Install the bolts and the cross brace. Tighten the bolts to 55 Nm (40 ft. lbs.).
4. Tighten the manifold ball flange nut to 12 Nm (106 in. lbs.).
5. Check the clearance between exhaust module and fuel tank. Clearance is 14mm (.55 in.).
6. Check the clearance at the rear tunnel reinforcement. Clearance is 15 - 20mm (.59 -.78 in.).
7. Adjust the clearance as necessary.
8. Tighten the ball flange nuts to 34 Nm (25 ft. lbs.).
9. Lower the vehicle.
10. Connect the negative battery cable.
11. Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.
