Challenger SRT-8 V8-6.1L (2009)
INSTALLATION
DEPLOYED PASSENGER AIRBAG
NOTE: For deployed passenger airbags, the instrument panel top pad must be replaced.
1. Clean powder residue from interior of vehicle See: Service and Repair.
2. Inspect and transfer all reusable components from the old instrument panel top pad to the new instrument panel top pad.
3. Position new passenger airbag into instrument panel cavity.
4. Install the two lower passenger airbag mounting bolts (2). Torque bolts to 11.6 Nm (103 in. lbs.).
5. Install the four left and right passenger airbag mounting screws (1). Torque screws to 2.8 Nm (25 in. lbs.).
6. Connect the passenger airbag electrical connector (3).
7. Install new instrument panel assembly See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel - Installation.
WARNING: Do not connect the battery negative cable See: Testing and Inspection/Component Tests and General Diagnostics . If the system test is
not performed first it may result in serious or fatal injury.
NONDEPLOYED PASSENGER AIRBAG
