Challenger SRT-8 V8-6.1L (2009)
a. Disconnect the battery positive cable clamp from the battery terminal (Figure 2).
b. Unlatch the battery retention strap.
c. Gently disconnect the battery vent hose from the battery vent nipple (Figure 3).
CAUTION:
Use care when disconnecting the battery vent hose from the battery. The vent hose nipple is made of plastic and can be damaged if not disconnected
properly.
d. Remove the battery hold down clamp and remove the battery from the vehicle.
e. Position the new battery in the battery tray.
f.
Install the battery hold down clamp.
Tighten the bolt to 35 in. lbs. (4 N.m).
g. Gently connect the battery vent hose to the battery nipple (Figure 3).
CAUTION:
Use care when connecting the battery vent hose to the battery vent nipple.
h. Latch the battery retention strap.
i.
Connect the battery positive cable (Figure 2).
3. Replace the transmission negative ground cable using the following procedure:
