Challenger SRT-8 V8-6.1L (2009)
1.
Open the hood. Install a battery charger and verify that the charging rate provides 13.2 to 13.5 volts. Do not allow the charger to time out during
the flash process. Set the battery charger timer (if so equipped) to continuous charge.
NOTE:
Use an accurate stand-alone voltmeter. The battery charger voltmeter may not be sufficiently accurate. Voltages outside of the specified range will
cause an unsuccessful flash. If voltage reading is too high, apply an electrical load by activating the park or headlamps and/or HVAC blower motor
to lower the voltage.
2.
Connect the StarMOBILE scan tool to the vehicle data link connector located under the steering column and place the ignition to the "RUN"
position.
3.
Power ON the StarMOBILE scan tool.
4.
Connect the CH9410 StarMOBILE scan tool ethernet cable to the StarMOBILE and the dealer's network drop.
5.
From the desktop, launch the "StarMOBILE Desktop Client" software.
6.
Establish a connection with the StarMOBILE scan tool.
7.
Select "ECU View".
8.
Select "WCM Wireless Control".
9.
Select "More Options".
10.
Select "ECU Flash".
11.
Select "Browse for New File".
12.
Enter your ID and password.
13.
Compare the highlighted software part number with the software part number displayed at the top of the screen.
>
If the part numbers are the same, the module is up to date and reprogramming is not required. Continue to Step 20.
>
If the software part numbers are different, continue with Step 14 to reprogram the module.
14.
Highlight the required flash file and select "Download to Client".
15.
Click the "Close" button and then the "Back" button.
16.
Highlight the desired file.
17.
Select "Update Controller," press the select button and follow the on-screen instructions.
18.
Resynchronize each Remote Keyless Entry (RKE) transmitter (also known as a FOBIK) using the following procedure:
a.
Remove the "Start" button cover, insert the RKE transmitter into the ignition switch and start the engine.
b.
Allow the engine to run for a minimum of 5 seconds.
c.
Turn off the vehicle and remove the RKE transmitter from the vehicle.
d.
Verify the function of the RKE transmitter to ensure proper operation.
e.
Repeat Steps 18a through 18d for all additional RKE transmitters.
f.
Install the "Start" button cover.
NOTE:
If the customer did not bring both RKE transmitters, be sure to explain the synchronization process to them so that he/she can synchronize their
other RKE transmitter(s).
19.
Clear any Diagnostic Trouble Codes (DTCs) as follows:
